EAGLE-300 concept plane by Robert Szikszo

Concept plane model and render by Robert Szikszo.



The EAGLE-300 is a Mach 2.5 concept supersonic airliner which can carry 300 people to roughly 6000 nm. Revolutionary in design and features compared to other airliners. Renders were made with an engineering CAD program. Hope you like them. I am still continuing the work on the interior and will probably make a movie presentation too at the end.

7 comments

Anonymous
Too bad it's not practical. Google "area rule," and change the fuselage, then it'll be a concept ;)
Romlel
I really like it ! it just that the rear landing gear seems strange to me... Perhaps a little rough, and seems fragile for an aircraft that size : Wouldn't it need to be "vertical" to better support the weight ?
Robert Szikszo
I think a concept airplane is a concept until many thousands of engineer workhours not implemented and several optimization and analyzing have not done. At airliners it is better to keep a nearly constant fuselage cross section, or it may look so ugly like the Boeing 2707-SST and will be hard to manufacture. At fighter planes it is easier to keep the area rule. I was thinking on that too, but as I said it is not a complete plan, only a concept ;)
Snafu
Wouldn't having the engines' intakes over the wing be a problem when taking off and landing? When one sees the kind of angle of attack the Concorde used to do...
Robert Szikszo
Of course a simple vertical landing gear strut is ideal but in this case the wing is too high above. The slanted gear strut starts from the center of fuselage and distributes the forces along the whole cross section of it.

The engine intakes are covered by the wing at high angle of attack. Therefore an additional intake can be opened in this case below the wing. Just like at the Mig-29 but here the rule is opposite because the engines are not below the wing. This, and some other features are not visible on these static images. Good sighting though ;)